Table of Contents
Advertisement
Section 3: Adjustments
Section 3: Adjustments
Adjustment Safety
!
DANGER
To avoid serious injury or death:
Always disengage power take-off before lifting implement up,
and never operate implement in the raised position. Objects
can be thrown at high speeds toward people or animals
Skid Extension Height
Refer to Figure 3-1:
IMPORTANT: The Wood Chipper operates best if
skid extensions are adjusted to support the unit with
driveline operating near level. This setting will also
increase the life of the driveline u-joints.
NOTE: This effects loading height for wood.
1.
Make sure power take-off is disengaged, gear
selector is in park, and park brake is set. Adjust
tractor 3-Point up or down until driveline is close to
level.
2. Place support blocks under the chipper but not under
skid extensions (#1) to keep chipper from drifting
down while adjusting skid extensions.
3. Lower Wood Chipper onto support blocks, shut
tractor engine off, and remove switch key.
4. Remove hex flange locknuts (#3) and bolts (#2).
5. Lower skid extensions (#1) to the ground and reinsert
1/2"-13 GR5 cap screws (#2). Secure cap screws
with existing hex flange locknuts (#3). Tighten
locknuts to the correct torque.
6. Raise tractor 3-Point up and remove support blocks.
7.
Lower unit until it is resting on its skid extensions.
24
WC1504 Wood Chipper 328-098M
Table of Contents
35685
Adjust Skid Extension Height
Figure 3-1
2/10/21
Advertisement
Table of Contents
