Antenna Connection - JVC LT-22DD22J Operating Instructions Manual

Antenna connection

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (A). Connections to other equipment is explained further on
P.32-35. If you have problems with reception, consult a specialist of antenna.
Back Side
M4 X 10
(K)
DVB-T antenna: Connect a DVB-T antenna if DVB-T is already available in your transmission area. Or
(A)
connect to an analogue cable connection.
The built-in tuner receives all analogue cable programmes and DVB-T channels.
AV2 input: Input for analogue AV-Signal (Composite) See P.35.
(B)
DIGITAL AUDIO COAXIAL output: digital output for CD/DVD & DVB-T (see pages 34, 35).
(C)
COMPONENT input: See P.35.
(D)
C.I. slot: for DVB-T-PayTV (if PayTV-provider supports this)
(E)
This unit supports the C.I. card of "Top Up TV" and "Boxer".
HDMI input (HDMI/DVI): See P.33.
(F)
HEADPHONE jack: Plug headphones with a mini plug (3.5 mm) into this jack.
(G)
PC-INPUT (PC): See P.32.
(H)
PC/DVI AUDIO input: See P.32, 33.
(I)
SCART socket (AV1): For the connection of SCART cables. See P.34.
(J)
AV1: Transmits RGB, S-Video and CVBS in, and CVBS tuner out.
Power supply: Connect the supplied power cable to an AC 220-240V/50Hz mains power supply only - do
(K)
not attempt to connect it to any other type of supply. Never try to repair a damaged AC power cord with
isolation-tape - this should be repaired by a specialist or replaced. Do not let your pet loose near the cable.
Animals biting into the cable could receive a fatal electric shock, and could cause hazard to others.
Bracket holes: To attach a wall mounting bracket (not supplied), attach where indicated in the drawing
(L)
above.
(M) To hang the television on a wall, remove these screws and then remove a stand.
Before performing work spread cushioning over the base area to lay the TV on.
Service connector cover: Please do not open this cover. There is a socket only for service purpose inside.
(N)
10
(I)
100 mm
100 mm
(L)
(M)
(H)
(N)
(J)
(B)
(A)
(C)
(D)
(E)
(F)
(G)