Os Installation - Contec XPT-T1000 Series Manual

XPT-T1000 Manual for OS Pre-installed Type (Windows 10 IoT Enterprise 2019 LTSC)
Aptio Setup Utility - Copyright © 2018 American Megatrends, Inc.
Main Advanced Chipset Security
Boot Configration
Setup Prompt Timeout 1
Bootup NumLock State [On]
Quiet Boot [Disabled]
Save & Exit Setup
Save configration and exit?
Yes No

2. OS installation

The USB DVD-ROM Drive will run UEFI boot, and after a short while Windows PE will start up.
[!!! WARNING !!!]
Initialize Storage.
Are you Sure? [Y/N]
I A
CImage Tool for Windows
Copyright<C> 2017 CONTEC CO., LTD.
Version X.X.X.X
Copy swm file: xxxxx.swm
[xx%] copied
A
CImage Tool for Windows
Copyright<C> 2017 CONTEC CO., LTD.
Version X.X.X.X
Copy swm file: xxxx.swm
[100%] Copied
Please Insert next disc [2/2] and type '[Enter]' key.
**************************************
Remove the System Restoration Disk
Press any key to reboot
**************************************
—
Recovery Method
Boot Save & Exit
Sets the system boot order
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-:Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
— 54 —
—
8. Press [F4] key, select [Save & Exit Setup]. Please
select [Yes] and press [ENTER] key.。This
restarts the system. UEFI boot will be carried
out from DVD-ROM drive connected USB.
Go to "2. OS installation".
1. When you receive the confirmation message,
please press [Y] key and [ENTER] key.
(If you do not continue the recovery,
press N key.)
2. HDD/SSD initialization and recovery
processing will be performed automatically.
3. The screen on the left will appear. Take out the
recovery media (Disc 1 of 2) and insert the
recovery media (Disc 2 of 2), then press
[Enter].
4. The left DOS prompt appears,
Remove the recovery media (Disc 1 of 2).
Insert the following recovery
media (Disc2 of 2). Press [Enter] key.
Recovery is performed automatically.