Table of Contents
Advertisement
- Remove 2 Screws fixing Digital P.C.B. Angle
7. Main P.C.B.
- Remove 2 Screws from Main P.C.B.
- Remove Screw from Front P.C.B.
- Unlock Main P.C.B. and Front P.C.B. from Bottom Plate
- Hold Hard Disc Drive and Digital P.C.B. carefully and put it
together with Main P.C.B. up side down on the Insulation Board.
- Connect the Extension Cable:
- between Main P.C.B. and Power P.C.B. with RFKZ0216
Caution 1
Red wire in the extension cable should be connected to (1) pin.
Caution2
Orginal screws should be used.
11.1.3. CHECKING AND REPLACING OF DVD-RAM DRIVE
1. Top Case
- Remove 2 Screws (A) on side and 3 rear Screws (B)
- Remove Top Case
2. Front Panel
- Unlock 2 Locking Tabs on side and 3 Locking Tabs on bottom
- Remove Front Panel
3. SD Card P.C.B.
- Remove 2 Screws
57
Advertisement
Table of Contents
