Assembly; Operation - Husqvarna 125B Operator's Manual

WARNING:
chapter before you assemble the
product.
To install the the blower tube and
nozzle on the product
Note:
The bolt must be sufficiently loose to put the
blower tube into the blower outlet. Turn the bolt
counterclockwise with a screwdriver to loosen it.
1. Align the rib on the upper blower tube with the
groove in the blower outlet. Move the tube into
position.
2. Turn the bolt clockwise with a screwdriver to
attach the tube.
Note:
Do not use any tool on the nut.
3. Align the slots on the lower blower tube with the
tabs on the upper blower tube. Move the lower
blower tube onto the upper blower tube.
4. Turn the lower blower tube clockwise until there
is a click.
To install the collection bag with
different vacuum tubes
WARNING:
before you attach the the tubes to the
product.
To assemble the collection bag
1. Open the collection bag.
2. Insert the collection bag tube from inside of the
bag to fit in the vacuum inlet opening.
3. Make sure that the elastic seats in the groove
(A).
WARNING:
the safety chapter before you operate
the product.
Fuel
To use fuel
CAUTION:
cycle engine. Use a mixture of gasoline
and two-cycle engine oil. Make sure to
use the correct quantity of oil in the
10

Assembly

Read the safety
Turn off the engine

Operation

Read and understand
This product has a two-
4. Close the zipper on the bag. (Fig. 18)
To install the collection bag tube
1. Remove the blower tube, if it is attached.
2. Align the rib on the collection bag tube (A) with
the groove in the blower outlet (B).
3. Push the collection bag tube fully onto the blower
outlet.
4. Insert the nut (C) in its opening.
5. Install the screw (D) and tighten with a
screwdriver to attach the tube. (Fig. 19)
To attach the vacuum tubes together
1. Align the arrow on the lower vacuum tube (A)
with the arrow on the upper vacuum tube (B).
2. Push the lower vacuum tube into the upper
vacuum tube.
3. Use a screwdriver to install the self-tapping
screw (C) that holds the tubes together. (Fig. 20)
To install the vacuum tubes
1. Insert the tip of a screwdriver into the latch area
of the vacuum inlet.
2. Turn the screwdriver to release the latch. (Fig.
21)
3. Hold the vacuum inlet cover open until the upper
vacuum tube is in place.
4. Align the ribs on the inside of the vacuum inlet
with the slots on the upper vacuum tube. Make
sure the lock symbol on the tube aligns with the
unlock symbol on the vacuum inlet. (Fig. 22)
5. Push the upper vacuum tube fully onto the
vacuum inlet.
6. Turn the upper vacuum tube clockwise until the
lock symbol on the tube aligns with the lock
symbol on the vacuum inlet. The tube makes a
click when it is correctly attached. (Fig. 23)
mixture. Incorrect ratio of gasoline and
oil can cause damage to the engine.
Gasoline
CAUTION:
an octane number less than 90 RON (87
AKI). This can cause damage to the
product.
Do not use gasoline with
237 - 010 - 23.09.2021