Installation Of Wired Room Controller - Carrier ClassiCOOL 53KDHT60N-518 Instruction Manual

INSTALLATION OF WIRED ROOM CONTROLLER

14.3 Installation Diagram of wired control
1. Wired remote controller
structure size figure
20
120
Unit : mm Figure A
19
12
10
84
14
44
46
60
INSTALLATION PROCEDURE
4.Back cover installation
Buckling position Back cover
Straight head Front cover
screwdriver
Screw hole installed on
the wall, use three
GB950-86 M4X20
Fig. (6)
Screw hole fixed on
Screw hole installed
the wall, use one
on 86 Electrician box,
GB950-86 M4X20
use two M4X25
Fig. (7.1)
GB823-88
86 Electrician box
Fig. (7.2)
1. Use straight head screwdriver to insert into the buckling position in the bottom of wire
controller, and spin the screwdriver to take down the back cover. (Pay attention to
spinning direction, otherwise will damage the back cover!) (Fig.5)
2. Use three GB950-86 M4X20 screws to directly install the back cover on the wall. (Fig.6)
3. Use two M4X25 GB823-88screws to install the back cover on the 86 electrician box,
and use one GB950-86 M4X20 screws for fixing on the wall. (Fig.7.1)
4. Adjust the length of two plastic screw bars in the accessory to be standard length
from the electrical box screw bar to the wall. Make sure when install the screw bar to
the electrical box screw bar, make it as flat as the wall. (Fig.7.2)
5. Use cross head screws to fix the wire controller bottom cover in the electric control
box through the screw bar. Make sure the wire controller bottom cover is on the same
level after installation, and then install the wire controller back to the bottom cover.
6. Over fasten the screw will lead to deformation of back cover.
.
2. Wiring Principle Sketch:
INDOOR MAIN
BOARD
47
1) This wired remote controller is compatible with the indoor unit
of V4+ heat recycling 3-pipe system and V4+ 2-pipe system.
2) Please do not connect the wired remote controller and a CCM.
to the same X, Y PORT, otherwise it will lead to conflict.
5.Wiring :
Upper left
wire outlet
Fig. (5)
Left
middle
side wire
outlet
B. Shielded wiring
Embedded 86 electrician box wiring
86 Electrician
box
Back cover
Signal
Avoid the water enter into the wired remote controller, use trap and putty to seal the connectors of
switching
wires during wiring installation. (Fig.10)
wires
When under installation, reserve certain length of the connecting wire for convenient to take down
the wired remote controller while during maintenance.
CAUTION
INDOOR UNIT
DISPLAY
PANEL
CAUTION
A. Wiring, three out letting positions
Top side
wire outlet
Cutting place
of top side wire
outlet
Fig. (8)
Wiring
Wall hole and wiring hole
hole
Diameter：Φ8 ~ Φ10
6.Front cover installation
After adjusting the front cover and then buckle the
front cover; avoid clamping the communication
switching wire during installation. (Fig.11)
Correct install the back cover and firmly buckle the
front cover and back cover, otherwise will make the
front cover drop off. (Fig. 12)
22
3-cores shield wire
RED
WHITE
2-cores wire
4-cores wire
WIRED REMOTE CONTROLLER
Cutting place
of upper
left wire outlet
Putty
Trap
CAUTION
Fig.11
CAUTION
INDOOR UNIT
CONNECTOR
Cutting place
of left middle
side wire outlet
Putty
Putty
Trap
Trap
Fig.12