Brother DCP-T226 Online User's Manual page 112

Home > Network > Wireless Network Settings
Wireless Network Using the One Push Method of Wi-Fi Protected Setup
Configure Your Machine for a Wireless Network Using the One Push
Method of Wi-Fi Protected Setup
Related Models: DCP-T420W/DCP-T425W/DCP-T426W/DCP-T428W
If your wireless access point/router supports WPS (Push Button Configuration), you can use WiFi Button/LED
on your machine's control panel to configure your wireless network settings.
1. Press WiFi Button/LED three times.
The WiFi Button/LED starts blinking.
2. Press the WPS button on your wireless access point/router.
If your wireless device is connected successfully, the Power LED and WiFi Button/LED are lit.
You have completed the wireless network setup. To install the drivers and software necessary to use your
machine, go to your model's Downloads page at support.brother.com.
(Windows) Or, use the Brother installation disc to set up your machine (not available in all countries).
Related Information
• Use the Wireless Network
> Use the Wireless Network
™
(WPS)
> Configure Your Machine for a
™
(WPS)
108