Table of Contents
Advertisement
INSTALL COMPONENTS TO PC BOARD
Start Here
B6 - 4-pin Bredblox
(see Figure F)
D16 - 1N4148 Diode
(see Figure G)
R14 - 100
5% 1/4W Resistor
(brown-black-brown-gold)
B5 - 4-pin Bredblox
(see Figure F)
R12 - 1k
5% 1/4W Resistor
(brown-black-red-gold)
R44 - 100
5% 1/4W Resistor
(brown-black-brown-gold)
D17 - 1N4148 Diode
(see Figure G)
J23 - Jumper Wire
(see Figure A)
Figure E
Mount the trim pot to the PC board as
shown below.
Figure EA
Bend the capacitors at a 45
soldering it to the PC board.
Hold the bredblox down flush
to the PC board from the top
legend side and solder the
metal pins in place.
melt the plastic pins with your
soldering iron to hold the
bredblox down as shown. Re-
tin the solder tip afterwards.
o
angle before
Figure F
Then,
Plastic Pins
Melt Pins
-29-
Continue
R48 - 22k
5% 1/4W Resistor
(red-red-orange-gold)
Q1 - 2N3904 Transistor
(see Figure C)
R47 - 330 5% 1/4W Resistor
(orange-orange-brown-gold)
R46 - 330
5% 1/4W Resistor
(orange-orange-brown-gold)
R45 - 22k
5% 1/4W Resistor
(red-red-orange-gold)
J16 - Jumper Wire
J15 - Jumper Wire
J14 - Jumper Wire
(see Figure A)
Q2 - 2N3906 Transistor
(see Figure C)
Figure G
Diodes have polarity. Mount with
band in the direction shown on the
PC board.
Band
Advertisement
Table of Contents
