INSTALL COMPLETED UNIT INTO CASE
Place the strain relief onto the line cord as shown in Figure AA.
Squeeze the two sections together with pliers as shown in Figure BB. Then, insert the strain relief into the
hole.
Lay the trainer inside of the case as shown in Figure CC.
Align the holes in the bottom case with those in the trainer and secure it into place with four #6 x 1/2" AB
screws and four #6 washer as shown in Figure DD.
Back Panel
Back Panel
Figure AA
Figure BB
#6 x 1/2" AB Screw
#6 Washer
Figure DD
Figure CC
-21-