FINAL ASSEMBLY
If you are immediately going to build the remaining sections, do not continue with the instructions on
this page and proceed to page 22.
Fasten the front panel in
place with four #6 x 3/8"
thread cutting screws, as
shown in Figure W.
Fasten the PC board to the
spacer on the front panel
with a fiber washer and a
4-40 x 1/4" screw (from
Power
Supply
Section)
from the foil side of the PC
board,
in
the
location
shown in Figure X.
Fasten the pots to the front
panel with an 8mm washer
and a 7mm nut, as shown
in Figure W.
Turn the shafts on the two
switches
fully
counter-
clockwise. Push the knobs
onto the shafts so that the
line on the knob is in line with
the end of the circle on the
front panel (see Figure Y). If
the knob is loose on the
shaft, insert a screwdriver
into the slot and expand the
slot slightly (see Figure Z).
4-40 x 1/4" Screw
Nuts 7mm
Washers 8mm
Figure W
Fiber Washer
Figure X
Knobs
#6 x 3/8" Thread
Cutting Screws
Figure Y
-20-
Nuts 7mm
Washers 8mm
#6 x 3/8" Thread
Cutting Screws
Figure Z