Gigabyte B450 AORUS ELITE V2 User Manual page 15

7) D_LED1/D_LED2 (Addressable LED Strip Headers)
The headers can be used to connect a standard 5050 Addressable LED strip, with maximum power rating
of 2A (12V or 5V) and maximum length of 5m or maximum number of 300 LEDs. There are 12V and 5V
Addressable LED strips. Be sure to verify the voltage requirements of your Addressable LED strip and set
the DLED_V_SW1 and DLED_V_SW2 jumpers accordingly.
1
1
D_LED1 D_LED2
Addressable
LED Strip
1
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS
Setup," "Peripherals."
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
8) DLED_V_SW1/DLED_V_SW2 (Addressable LED Strip Power Select Jumpers)
The jumpers allow you to select the supply voltage of the D_LED1 and D_LED2 headers. Be sure to verify
the voltage requirements of your addressable LED strip and set the correct voltage with this jumper before
connection. Incorrect connection may lead to the damage of the LED strip.
1-2: 5V (Default)
1
2-3: 12V
1
DLED_V_SW1
Pin No. Definition
1 V (5V)
2 Data
3 No Pin
4 GND
Connect your addressable LED strip to the header. There are 12V and
5V addressable LED strips. Be sure to verify the voltage requirements
of your addressable LED strip and set the DLED_V_SW1 and
DLED_V_SW2 jumpers accordingly. The power pin (marked with a
triangle on the plug) of the LED strip must be connected to Pin 1 of the
addressable LED strip header. Incorrect connection may lead to the
damage of the LED strip.
1-2: 5V (Default)
1
2-3: 12V
1
DLED_V_SW2
- 15 -
1 2 3
1