Table of Contents
Advertisement
Timer Programming
This function allows you to select programmes that you want to be reminded
to watch or record to the USB HDD.
1. Select the forthcoming programme and press
2. Select
USB HDD Rec.
To check / change / cancel a timer event
●
Recording > Timer Programming > Editing Timer Programming
LED turns to orange in Standby mode when
●
To return to
TV Guide
●
BACK/RETURN
If you select the current programme, a confirmation screen asking
●
whether you want to watch or record the programme appears. Select
Timer Programming
the time you finish the timer event setting.
is displayed on the TV Guide screen if
●
from
TV
Guide.
Depending on the country you select, you can set
●
Recording
(see below).
= Note =
Not valid in Analogue
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
No other channels can be selected while recording of
●
is in progress.
When recording programmes to the USB HDD, be sure to format the USB
●
HDD and enable it to record in
Recording > USB HDD setup
■
Signal Supported Recording
Signal Supported Recording
information from the TV Guide; if programme start and end times are changed
by the broadcaster, the timer event will follow the change. Note that
Supported Recording
from broadcasters.
The availability of this function depends on the country and TV mode you
●
select.
is displayed on the timer event if
●
/
Reminder
and press
and press
OK
to set
only works reliably if correct time information is
USB Device
is
Timer Programming
only works reliably if correct information is received
Signal Supported Recording
- 72 -
OK
to access.
OK
to set.
Timer Programming
USB HDD Rec.
to record from
Timer Programming
Signal Supported
Timer Programming
Setup.
which is controlled by
is set.
is set
Signal
is set.
Advertisement
Table of Contents
