Bottom Drawer - GE PGMS5PJ Manual

REMOVING THE FREEZER DRAWERS
The freezer drawers can be removed, if needed, to
fit through tight areas.
Read these instructions completely and carefully.

BOTTOM DRAWER

REMOVE THE BASKET
1
Open the bottom freezer drawer until it stops.
A
Pull the divider forward until the rear locating tabs
B
are out of the slots. Turn the divider slightly to the
side to release the front locating tabs and lift out.
The freezer basket rests on the metal slide brackets
C
and is held in place with swing locks.
D Turn the swing locks from horizontal to vertical
position.
Lift the front of the basket up, rotate it toward you,
E
and bring it straight up to remove.
Lift the back portion of the basket up and out
F
of the drawer.
Installation Instructions
A
(cont.)
REMOVE THE DRAWER FRONT FROM
2
THE SLIDES
A Remove the hex-head screw from each side
of the rail assembly.
Tilt the drawer front toward the refrigerator
B
and lift out.
Rail
assembly
Screw
Set the drawer front on a non-scratching
C
surface.
D Push the rail assemblies back into the cabinet.
REMOVE THE BASE GRILLE
3
(if needed)
If, after removing the freezer drawer and
refrigerator door, the refrigerator will still not fit
through a doorway, the base grille can be
removed.
A Remove the 2 Phillips-head screws on either
side of the base grille.
Pull the grille straight out.
B