GE PGMS5PJ Manual page 62

INSTALLING THE REFRIGERATOR
REMOVE THE FRESH FOOD
6
DOOR HANDLE
(For placement in the installation location or
reversal of the handles – on some models)
Stainless steel (on some models):
REMOVING THE
A
DOOR HANDLE:
Loosen the set
screws with the
3/32ʺ Allen wrench
and remove the
handle. NOTE: For
Double Door models,
follow the same
procedure on the
opposite door.
Plastic handle (on some models):
REMOVING THE DOOR HANDLE: Depress the tab on
A
the underside of the handle and slide the handle up
and off of the mounting fasteners.
REVERSING THE
DOOR HANDLE
(on some models):
• Remove the
handle mounting
fasteners with a
1/4ʺ Allen wrench
and transfer the
handle mounting
fasteners to the
right side.
• Remove the
logo badge.
• Remove and
transfer the plug
button to the left
side of the fresh food door. NOTE: Use a flat plastic
edge to prevent damaging the door. Remove any
adhesive on the door with a mild detergent. Remove
the paper covering on the adhesive backing on the
logo badge prior to carefully attaching the badge to
the door.
Installation Instructions
A
B
Mounting
Fasteners
(appearance may vary)
B
A
Mounting
Fasteners
(appearance may vary)
(cont.)
REMOVE THE TOP AND BOTTOM
7
FREEZER DRAWER HANDLES
Stainless steel and plastic handles:
Loosen the set screws located on the underside of
A
the handle with the 1/8ʺ Allen wrench and remove
the handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4ʺ Allen wrench.
Badge
A
A
Badge
62