Appliance Parameters; Airways Indicator; Conductivity - Miele TXR 860 WP Operating Instructions Manual

Appliance parameters

Airways indicator

Lint should be removed after drying. In
addition, this indicator will remind you
to clean the filters when a certain
amount of lint has collected in them:

Clean the lint and plinth filters. See the
Operating Instructions for more
information.
You can decide at what level of lint
this reminder should be given.
Options
You will have an idea of how often this
should be done after a few drying
programs.
- Off
This reminder does not appear.
However, if there is a very severe
blockage in the ducting, the program
will be cancelled and the fault
message

Clean the lint filter. Check the airways.
will appear in the display regardless
of this option.
- Heavy
The reminder only appears when
there is a heavy build-up of lint.
- Normal (factory setting)
- Delicate
The reminder appears when there is
only a small build-up of lint.

Conductivity

This setting is only relevant for regions
with very soft water.
Very soft water can result in
unsatisfactory drying results.
You should only select this setting if
the water used for washing the
laundry is extremely soft with a
conductivity reading (electrical
conductivity) less than 150 μS/cm.
Contact your local water authority for
the conductivity level of your
domestic water supply.
Options
- Normal (factory setting)
- low <150mS (only for regions with
very soft water)
Settings
97