Troubleshooting Guide - Simpson ALH3228 Instruction Manual

ENGINE
Covered by engine manufacturer warranty. See engine manual.
HIGH pRESSURE pUMp (DEFECTS IN MATERIAL AND WORkMANSHIp)
Two (2) years from date of purchase.
FRAME (DEFECTS IN MATERIAL AND WORkMANSHIp)
Ten (10) year from date of purchase.
OTHER COMpONENTS (DEFECTS IN MATERIAL AND WORkMANSHIp)
Includes nozzles, hoses, spray guns, wands, tires, feet
Ninety (90) days from date of purchase.
OPERATIONAL
ISSUE
Engine will
not start
(see Engine
Owner's
Manual for
further engine
troubleshooting)
No or low
pressure
(initial use)
TROUBLE SHOOTING GUIDE
POSSIBLE CAUSE
No fuel
Pressure builds up after
two pulls on the recoil
starter or after initial use
Choke lever in the "No
Choke" position
Spark plug wire not attached
Engine switch in OFF
po si tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time.
Spray wand not in
high pressure
Low water supply
Leak at high pressure
hose fitting
Nozzle obstructed
Water filter screen clogged
SOLUTION
Add fresh fuel
Squeeze gun trigger to relieve
pres sure
Move choke to the "Choke"
po si tion
Attach spark plug wire
Place engine switch
in ON position.
Move choke to the "No
Choke"po si tion.
See how to Use Spray
Wand instructions in the
Operation Section
Water supply must be at
least 5 gpm @ 20 PSI
Repair leak. Apply sealant
tape if necessary
See Nozzle Cleaning
instructions in the
Maintenance section
Remove and clean filter.
See Cleaning Water Inlet
filter paragraph in the
Maintenance section for
the correct procedure
20- ENG