Assembly Instructions - Impex MARCY NS-653 Owner's Manual

ASSEMBLY INSTRUCTION
NOTE: It is strongly recommended that two or more people assemble this bike to
avoid possible injury. Tools required assembling this bike: Allen Wrench and
Crossing Wrench packed in Hardware Pack.
STEP 1 (See Diagram1)
A). Remove the plastic protection caps from end of Rear Support (#2), remove protection
cap on top of Front Post (#3).
B.) Pull out the Front Post Lock Pin (#29). Loosen the Lock Knob (#24) on Front Post (#3);
pull Front Post forward, and fasten the Lock Knob (#24). Insert back Front Post Lock Pin
(#29).
C.) Pull and extend the Rear Support (#2). Insert the Rear Support Lock Pin (#27) into the
upper hole to firmly lock Rear Support in position.
6
DIAGRAM 1