3-Wire Grounded Junction Box; Mobile Homes - Electrolux ICON Professional E30DF74GPS Installation Instructions Manual

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
Four Conductor Wire Connection to Range

(mobile homes)

1. Remove the screws at the lower end of the rear wire
access cover or panel, then remove the access cover
or lift the lower part of the access panel to expose
range terminal connection block (Fig. 7 or 8).
2. Remove the three loose nuts (after you removed the
rubber band) on the terminal block using a 3/8" nut
driver or socket.
3. Remove the grounding strap from the terminal block
and from the appliance frame.
4. Connect the ground wire (green) of the power supply
cord to the frame of the appliance with the ground
screw, using the hole in the frame where the ground
strap was removed (see Figure 10).
5. Connect the neutral wire of the power supply cord to
the center silver-colored terminal of the terminal
block, and connect the other wires to the outer
terminals. Match terminal and power supply wires by
color.
6. Replace the 3 nuts on the terminal block (see Figure 10).
7. Replace the rear access panel using the screws
removed on step 1.
Figure 10
Four Conductor or Wire Connection to Range
(Model with Electric Oven and Gas Cooktop)
Direct Electrical Connection to the Circuit
Breaker, Fuse Box or Junction Box
If the appliance is connected directly to the circuit breaker,
fuse box or junction box, use flexible, armored or non
metallic sheathed copper cable (with grounding wire).
Supply a U.L. listed strain-relief at each end of the cable.
At the appliance end, the cable goes through the Direct
Connection Hole (see Figure 10) on the Cord Mounting
Plate. Wire sizes (copper wire only) and connections must
conform to the rating of the appliance.
Where local codes permit connecting the appliance
cable ground wire to the power supply cable
neutral (white) wire (see Figure 11).
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:
Connect appliance and power supply cable wires as
shown in figure 11.
Cable from Power Supply
White Wire
(Neutral)
Red Wires
Ground Wire
(Bare or Green Wire)
Cable from appliance

3-WIRE GROUNDED JUNCTION BOX

Improper connection of aluminum
house wiring to copper leads can result in a short
circuit or fire. Use only connectors designed for
joining copper to aluminum, and follow the
manufacturer's recommended procedure closely.
You may not ground the oven
through the neutral (white) wire if oven is used in
a new branch circuit installation (1996 NEC), mobile
home, recreational vehicle, or where local codes do
not permit grounding through the neutral (white)
wire. When grounding through the neutral (white)
wire is prohibited, you must use a 4-wire power
supply cable. See Figure 12. Failure to heed this
warning may result in electrocution or other
serious personal injury.
6
Black
Wires
Junction
Box
White Wire
(Neutral)
U.L.-Listed
Conduit Connector
(or CSA listed)
Figure 11