IndraControl XFE01.1-SY-01 Safety Ex-
tension Module
10.3 Mounting
NOTICE
Before mounting or dismounting components, disconnect the control - includ-
●
ing its components - from voltage
Connect the voltage only after the control and its components have been set
●
up
The extension bus base module can only be mounted if the control is
not attached to the control bus base module.
1. Press the IndraControl extension bus base modules for the IndraControl
extension modules on the top-hat rail on the left next to the control bus
base module until all latchings are safely closed (see (A) in the following
figure).
2. Move the first IndraControl extension bus base module (see (B) to the right
and connect the IndraControl extension bus base module with the bus
base module of the control (see (D) in the following figure).
3. Move the other IndraControl extension bus base modules to the right until
all bus base modules are connected to each other (see (C) in the following
figure).
Fig. 10-3: Interconnect extension bus base modules and connect them to the control
bus base module
4. Fit the extension modules and the XMx control on the bus bases.
Mounting, dismounting and electric installation
Destruction of components due to mounting un-
der voltage!
R911376654_Edition 04 Bosch Rexroth AG
21/41