Table of Contents
Advertisement
(2) Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
(3) Stop the engine and leave it for 5-10 min-
utes.
(4) Remove the top cowling.
(5) Remove the oil filler cap.
1
1. Oil filler cap
2. Oil lubrication check window
TIP:
The oil lubrication check window does not in-
dicate the engine oil level. Use the oil lubrica-
tion check window to make sure that the
engine is being lubricated with oil while it is
running.
(6) Insert the tube of the oil changer into the
oil filler hole, and then extract the engine
oil completely using the oil changer.
ZMU08448
TIP:
2
TIP:
1
1. Oil changer
When using an oil changer, skip steps 7 and
8.
(7) Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Remove the drain screw and gasket
while holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
1. Drain screw
2. Gasket
If the oil does not drain easily, change the tilt
angle or turn the outboard motor to port and
starboard to drain the oil.
(8) Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
Maintenance
2
1
54
Advertisement
Table of Contents
