Important Notes - Roland CDR-88RW-3 Manual

IMPORTANT NOTES

291b
In addition to the items listed under "IMPORTANT SAFETY INSTRUCTIONS" and "USING THE
UNIT SAFELY" on pages 10 and 11, please read and observe the following:
Power Supply
301
• Do not use this unit on the same power circuit
with any device that will generate line noise
(such as an electric motor or variable lighting
system).
307
• Before connecting this unit to other devices,
turn off the power to all units. This will help
prevent malfunctions and/or damage to
speakers or other devices.
Placement
354a
• Do not expose the unit to direct sunlight, place
it near devices that radiate heat, leave it inside
an enclosed vehicle, or otherwise subject it to
temperature extremes. Excessive heat can
deform or discolor the unit.
355
• To avoid possible breakdown, do not use the
unit in a wet area, such as an area exposed to
rain or other moisture.
Maintenance
401a
• For everyday cleaning wipe the unit with a
soft, dry cloth or one that has been slightly
dampened with water. To remove stubborn
dirt, use a cloth impregnated with a mild, non-
abrasive detergent. Afterwards, be sure to
wipe the unit thoroughly with a soft, dry cloth.
402
• Never use benzine, thinners, alcohol or
solvents of any kind, to avoid the possibility of
discoloration and/or deformation.
Electric wave obstacle
***
• CDR-88RW-3 is authorized to conform to the
chapter 15, and the regulation for the division
B digital devices of the FCC regulation, which
is for the prevention of electric wave obstacle
by the installation in the residence.
CDR-88RW-3 generates, uses or radiates radio
frequency energy, and may cause obstacle to
the radio communication if you use it in
irregular manners.
If the wave jamming may happen on the radio
and TV, please try the following. But we
cannot guarantee that the obstacle is
completely eliminated.
• Turn off the power of CDR-88RD-3.
• Change the location and direction of the
antennae of the radio and TV.
12
• Keep CDR-88RW-3 and the receiver away.
• Supply the power to CDR-88RW-3 and the
receiver from the different power outlet.
• Consult your nearest Roland Service Center
or authorized Roland distributor in your
country.
Laser beam
***
• If you operate the operating section,
controlling section and drive section of this
device in irregular manners, harmful ray may
be radiated. Laser beam radiated from the
optical pickup is harmful to your eyes and
body. Please observe the following.
• Do not attempt to open the optical pickup
unit.
• When you need repair service, call your
nearest Roland Service Center or authorized
Roland distributor in your country.
Handling the CD-RW Drive
601
• Before being shipped, a cardboard insert was
placed in the disk drive to protect it from
vibration during transport. Press the EJECT
button to remove this material before you use
the unit. This material should be saved, and
reinserted whenever the unit is transported.
602
• Install the unit on a solid, level surface in an
area free from vibration.
603
• Avoid using the unit immediately after it has
been moved to a location with a level of
humidity that is greatly different than its
former location. Rapid changes in the
environment can cause condensation to form
inside the drive, which will adversely affect
the operation of the drive and/or damage
disks. When the unit has been moved, allow it
to become accustomed to the new
environment (allow a few hours) before
operating it.
***
• Optical pickup is dust-proof. Using a CD type
pickup cleaner may damage.
604
• To insert a disk, push it gently but firmly into
the drive—it will click into place. To remove a
disk, press the EJECT button firmly. Do not
use excessive force to remove a disk which is
lodged in the drive.