GE Advantium PSB9240BL Installation Instructions Manual page 8

Preparation
NOTE: MODEL ZSC2202
INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.
PREPARE THE OPENING
The Advantium 240V can be installed in
combination with other Built-In appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium 240V Installation:
Order a 30" wide single oven cabinet or cut the
opening in a wall to the dimensions shown.
30"
21"
36-3/4"
Min.
* For existing cutouts, a maximum width of
28-1/2" is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
• Always maintain 36-3/4" minimum height
from the floor to the cutout in any single or
combined installation.
• Allow the following clearances around the
cutout on the front surface of the cabinet: 5/8"
from the top, 2-3/8" from the side edges, and
3/4" from the bottom. (Note: these refer to
minimum clearances required for installation
and do not reflect actual product dimensions.)
• Oven overlaps will conceal cut edges on all
sides of the opening.
Installation Preparation
WITH
CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE
23-1/2"
25-1/4"
Min.*
Construct
Base
Min. 3/8"
Plywood
Supported
by 2x4
or 2x2
Runners all
Four Sides
an Accessory Storage Drawer
PREPARE THE OPENING
Single Advantium 240V Installation (cont.)
When installed over a single oven or a warming
drawer, allow at least 2" between the two
openings. This separation will provide clearance
for bottom overlap of the Advantium 240V and the
other appliance overlaps.
Construct a solid oven floor of 3/8" min. thick
plywood supported by 2 x 4 or 2 x 2 runners on all
sides.
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
Installation over a Warming Drawer:
30"
36-3/4"
Min.
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
NOTE: Additional clearances between the
cutouts may be required. Check to be sure
the oven supports above the Warming Drawer
location do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.
8
23-1/2"
25-1/4"
Min.*
21"
(CONT.)
Construct
Solid Bottom
Min. 3/8"
Plywood
Supported
by 2x4 or 2x2
Runners all
Four Sides
2" Min.
(3" recommended)
Per warming
drawer
requirement