GE Advantium PSB9240BL Installation Instructions Manual page 14

Assembly to Advantium 240V Built-in Speedcook Oven
1 REMOVE PACKAGING AND
PARTS
• Remove the drawer from the carton.
• Remove all packing material and tape.
• Open the drawer and remove any parts inside.
• Locate parts.
Assembly
Instructions
2 ASSEMBLING THE OVEN TO
DRAWER
A Place storage drawer on a surface with the
front of drawer hanging over the edge of the
surface. Not placing the front edge of
drawer over the edge of the surface may
result in damage to the drawer since the
front edge of drawer hangs below the
bottom of drawer.
B Place the oven on top of the storage
drawer. Make sure that the back and sides
of the oven align with the back and sides of
drawer.
NOTE: The bottom of the oven side flanges
will sit directly in front of the top of the
storage drawer side flanges.
Side Supports (2)
Screws (2 Sets)
ASSEMBLING THE OVEN TO
DRAWER
(CONT.)
C Remove the front two bottom screws on
each side of the oven and the top center
screw on each side of the storage drawer.
D Place the side supports into the tabs on the
drawer and secure using the screws
supplied and the screws removed in Step
C.
E
The oven and storage drawer assembly is
now ready to be installed. Return to the
Advantium 240V Built-In SpeedCook Oven
Installation Instructions to complete the
installation.
14