Table of Contents
Advertisement
o Place the front brackets on the horizontal line. Ensure that the
bottom of each bracket is in line with the horizontal line that you
have just marked.
o IMPORTANT: The distance on either side of the centre line must
be equal.
o Using a drill with a 3 mm drill bit; drill a hole on the two marks
that you have just made. The hole should be drilled to a depth of
5 – 8 mm.
5) Measure the distance
between the two screwholes
on the top of the fridge door.
6) Draw a line that is the
length of that measurement
(D) on the rear of the
furniture door. This line
should be drawn at the point
that you marked in step 4.
It must be made at a 90°
angle to the centre line.
7) Using a bradawl, mark the
centre of the holes in the
front brackets.
o Remove the brackets.
21
Advertisement
Table of Contents
