Impex MARCY SM-4008 Owner's Manual page 16

Upper Cable assembly instruction Step-12A
A.) Attach a Pulley (#62) to the open pulley shaft. Secure it with one M10 x 1 ¾" Allen Bolt (#93), one
Ø ¾" Washer (#107), and one Cable Retainer (#78).
B.) Draw the Cable around the Pulley then to the next open pulley shaft on Rear Upper Frame (#18).
Attach a Pulley to the open shaft. Secure it with one M10 x 2 ¾" Allen Bolt (#97), two Ø ¾"
Washers 9#107), one Cable Retainer (#78), and one M10 Aircraft Nut (#110).
C.) Draw the Cable around the Pulley and to the open bracket on right side of the Rear Upper Frame
(#18). Attach a Pulley (#62) to the bracket. Secure it with one M10 x 5" Allen Bolt (#99), one Cable
Retainer (#78), two Ø ¾" Washers (#107), and one M10 Aircraft Nut (#110).
D.) Draw the Cable around the Pulley and then downward. Attach a Pulley to a Single Floating Pulley
Bracket (#34). Secure the Pulley with one M10 x 2" Allen Bolt (#94), two Ø ¾" Washers (#107),
two Cable Retainers (#78), and one M10 Aircraft Nut (#110). Draw the Cable around the Pulley
and upward to the open bracket on the left side of the Rear Upper Frame. Let the Pulley hanging
for now.
E.) Remove the M10 x5" Allen Bolt (#99), Nut, and Washer installed in Procedure C. Attach a Pulley
onto the M10 x 5" Allen Bolt, then attach a Cable Retainer (#78) to the Pulley, and secure with the
removed Washer and Nut.
F.) Draw the Cable to an open shaft on Rear Upper Frame. Secure it with M10 x 2 ¾" Allen Bolt
(#97), two Ø ¾" Washers 9#107), one Cable Retainer (#78), and one M10 Aircraft Nut (#110).
G.) Draw the Cable to next open shaft. Attach a Pulley to the open shaft. Secure it with one M10 x 1
¾" Allen Bolt (#93), one Ø ¾" Washer (#107), and one Cable Retainer (#78).
H.) Draw the Cable to the opening on the left Upper Side Frame (#7).
©IMPEX INC.
15
www.marcypro.com