Table of Contents
Advertisement
English
4
► Place the handlebar (4) in the lower clamp
molding (1) so that distance A is no more than
15 cm (6 in).
► Place the upper clamp molding (2) in position
and press it down.
► Insert the clamp screw (3).
► Line up the handlebar (4) at a right angle to
the drive tube.
► Tighten down the clamp screw (3) firmly.
14
A
1
7
5
6
► Take out the screw (5), the nut (6) remains in
the control handle (7).
► Push the control handle onto the handlebar (4)
until the holes (9) line up – the throttle trig‐
ger (8) must point towards the gearbox.
► Insert the screw and tighten it down firmly.
► Go to "Adjusting the Throttle Cable".
Swinging handlebar into transport position
4 Mounting the Bike Handle
8
7
9
4
9
3
7
0458-433-0121-B
Advertisement
Table of Contents
