Installation In Racks With 10-32 Threaded Holes - HP StorageWorks Reference Manual

Installation in racks with 10-32 threaded holes

For installation in racks with 10-32 threaded holes in the vertical mounting bars the pins supplied on
the rails must be removed. The rails will be attached with user-supplied 10-32 x.375 screws.
1. Remove the pins and threaded plates from both ends of each outer rack rail. See
These pieces will not be used.
Figure 18 Remove the pins and mounting hardware from the rack rail
NOTE: The ends of the rack rails are marked FRONT and REAR for proper orientation.
2. Attach the front mounting plate of each outer rail to the rack using four 10-32 screws in the
previously marked holes in the front vertical mounting bars of the rack. See
2
Figure 19 Installing the rack rails in front of rack
24 Rack Installation
1
1
1
15114
15119
Figure 18.
Figure 19.