Tape Drive Installation - HP StorageWorks Reference Manual

2

Tape Drive Installation

A 3/16" (5mm) flat-blade screwdriver or T-15 Torx driver may be required to install a tape drive in
the 1U tape enclosure.
CAUTION: To avoid damaging the equipment due to electrostatic discharge, be sure to review and
practice the procedures in Appendix B before handling the tape drives.
To install a tape drive:
Remove the top access panel as shown.
1.
3
2
1
15107
Figure 5 Removing top access panel
1U Rackmount Tape Enclosure Reference Guide 13