Table of Contents
Advertisement
Input Priority
This function is used to select which PC will have priority to control the
monitor when utilizing two PCs.
As you can see in the picture, there are three settings available:
"Signal 1", "Signal 2" or "Manual". The default priority setting is
"Signal 1".
The monitor constantly checks the input signals and switches
automatically in accordance with the "Input Priority" settings (see chart
below). Once a priority is set, whenever a change of signal is detected at
the selected input, the monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor
automatically detects and displays that signal.
Priority setting
56
2
USING THE SCREENMANAGER
Performance
If signals from both inputs are present, the monitor
Signal 1
gives preference to Signal 1 for the cases shown
below:
•
When the power of the monitor is turned ON
(see note 1).
•
When the signal input to Signal 1 is changed even
if active input was Signal 2.
Signal 2
If signals from both inputs are present, the monitor
gives preference to Signal 2 for the cases shown
below:
•
When the power of the monitor is turned ON
(see note 1).
•
When the signal input to Signal 2 is changed
even if active input was Signal 1.
Manual
The monitor will not detect signals automatically in
this mode. Select the active input by pressing the
input signal selection button on the monitor's front
panel.
Advertisement
Table of Contents
