Quectel BG96 Manual page 38

The USB interface is recommended to be reserved for firmware upgrade in customers' designs. The
following figure shows a reference circuit of USB interface.
Module
USB_VBUS
USB_DM
USB_DP
GND
A common mode choke L1 is recommended to be added in series between the module and customer's
MCU in order to suppress EMI spurious transmission. Meanwhile, the 0Ω resistors (R3 and R4) should be
added in series between the module and the test points so as to facilitate debugging, and the resistors are
not mounted by default. In order to ensure the integrity of USB data line signal, L1/R3/R4 components
must be placed close to the module, and also these resistors should be placed close to each other. The
extra stubs of trace must be as short as possible.
The following principles should be complied with while designing the USB interface, so as to meet USB
2.0 specification.

It is important to route the USB signal traces as differential pairs with total grounding. The impedance
of USB differential trace is 90Ω.

Do not route signal traces under crystals, oscillators, magnetic devices and RF signal traces. It is
important to route the USB differential traces in inner-layer with ground shielding on not only upper
and lower layers but also right and left sides.

Pay attention to the influence of junction capacitance of ESD protection devices on USB data lines.
Typically, the capacitance value should be less than 2pF.

Keep the ESD protection devices as close to the USB connector as possible.
NOTE
BG96 module can only be used as a slave device.
BG96_Hardware_Design
Minimize these stubs
R3
R4
VDD
L1
Close to Module
Figure 15: Reference Circuit of USB Interface
Test Points
NM_0R
NM_0R
ESD Array
LPWA Module Series
BG96 Hardware Design
MCU
USB_DM
USB_DP
GND
37 / 79