Technics SB-G90M2 Owner's Manual page 14

Placing the speakers using the rubber feet
Attach the rubber feet (4 pcs) to the recesses on the base plates in advance.
≥ Peel off the backing paper from the rubber feet, and push them firmly into the base plates without touching the adhesive
surface of the rubber feet.
≥ Panasonic is not responsible for any accidents or damage caused by improper assembly or handling of the product. Do
not attach the accessories in any other way than instructed in this Owner's Manual.
≥ Each speaker weighs approximately 35 kg (78 lbs). Ensure that the work is done by at least two people. Be careful not to
catch your fingers or toes between the speaker and the floor or tip over the speaker.
≥ Each rubber feet will be taking weights of 8 kg (17.6 lbs.) or more. This means that marks and indentations can occur in the
installation location.
≥ Dragging the speaker along the floor may cause the rubber feet to peel off.
When changing the installation location of the speaker, always use at least two people to lift it.
To avoid floor damage, have a thick mat (or similar) available. Place it in the unpacking location in advance.
1 Place the speaker vertically on a thick mat (or similar).
2 Remove the protective bags (2 pcs) and the cardboard covering the speaker.
3 Hold the speaker so that it is tilted forward and move it to the installation location.
Hold the speaker so that
your hands do not touch the
speaker unit.
14
(014)