Jupper Setting - Intel G41 User Manual

3-3 Jumper Setting
(1) Keyboard/Mouse Power-on Enabled/Disabled: JP1
(2) USB Power-on Enabled/Disabled: JP3
(3) CMOS RAM Clear (3-pin): JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM
short 1-2 pins of JBAT to store the CMOS data.
To clear the CMOS, follow the procedure below (for MI5-G41SGMD2-LF only):
1. Turn off the system and unplug the AC power
2. Remove ATX power cable from ATX power connector
3. Locate JBAT and short pins 2-3 for a few seconds
4. Return JBAT to its normal setting by shorting pins 1-2
5. Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1. Troubleshooting
2. Forget password
3. After over clocking system boot fail
JP1
1-2 Closed KB/MSPower ON Disable (Default)
Keyboard/Mouse Power On Setting
JP3
1-2 Closed: USB Power On Disable (Default)
2-3 Closed KB/MS Power ON Enabled
2-3 Closed: USB Power On Enabled
USB Power On Setting
15
JP1
JP3