How To Use The Blind Stitch Presser Foot; How To Use The Waste Collector - JUKI MO-204D Instruction Manual

Settings and practical sewing

■ How to use the blind stitch presser foot

Pin
1. Installing presser foot
When you want to remove the needle
Caution
or change the presser foot, be sure to
turn the power OFF.
A
B
Presser foot
holder
1) Remove the needle on the left side.
2) Move up the presser foot lifting lever.
3) Push section A of the presser foot holder to detach the
presser foot that has been used up to the present.
4) Move up the presser foot lifting lever until it will go no
further. Place the pin of blind stitch presser foot right
under the presser foot holder. Then, lower the presser
foot lifting lever. The blind stitch presser foot will be
automatically mounted to the holder by lowering the
lever.
2. Turn the stitch length adjustment dial to "4"
MO-214D
Stitch length
adjustment
dial
Marking
Guide adjustment screw
Guide plate
MO-204D
3. Fold the material and put it under the
presser foot
Fabric
(wrong side)
4. Sewing and finishing
Fabric
(wrong side)
In order to perform sewing while putting the crease of the
material against the guide plate, loosen the guide plate
setscrew and adjust the guide plate position to allow the
needle to enter the material at the point that is
1 to 1.5 mm inside the
crease of material.
Then, tighten the
guide plate setscrew.

■ How to use the Waste Collector

The waste collector is used for collecting the waste mate-
rial that is trimmed off during sewing.
1) Insert the waste collector between the sewing machine
and the machine table.
2) Pressing waste collector against the looper cover, shift
the former to the left.
* When the waste
collector is filled with
waste materials,
remove the waste
collector and empty
out it.
Place the material under
the presser foot with its
wrong side faced upward.
Needle
Fabric
Guide adjustment
screw
Guide plate
Fabric fold
Fabric Fabric
(wrong side) (right side)
Guide
plate
26