(When Replacing The Hard Disk Drives) - Panasonic WJ-NX200K Installation Manual

2 Installation of the hard disk drive
Step 4
Insert the HDD bracket with the hard disk drive all the way
into the HDD slot, and secure the HDD bracket with the
screws removed in Step 2.
HDD bracket screw

(When replacing the hard disk drives)

When replacing a hard disk drive with another one, it is necessary to perform the removal process. In this case, do the
following.
Step 1
Perform the removal process of the hard disk drive.
(☞ Operating Instructions (PDF))
Step 2
Turn off the power of the recorder. (☞ Page 26)
Step 3
Pull out the HDD bracket from the rear panel of the
recorder by referring to Step 2 of "Install the hard disk
drives" (☞ page 13).
Step 4
Install the hard disk drive into the HDD bracket by referring
to Step 3 of "Install the hard disk drives" (☞ page 13).
14
(continued)
Step 5
Turn on the power of the recorder. (☞ Page 25)
→ New hard disk drive will be formatted automatically. →
When the formatting is completed, the hard disk drive
will become operable.
When the hard disk drive is formerly used for recording,
perform the link process (☞ Operating Instructions
(PDF)) on the "HDD management" page.
The status of hard disk drive can be checked on the
setup menu - the "Maintenance" page - the "HDD infor-
mation" tab. (☞ Operating Instructions (PDF))
Step 5
Insert the HDD bracket with the hard disk drive into the
HDD slot by referring to Step 4 of "Install the hard disk
drives" (☞ page 14).
Step 6
Turn on the power of the recorder. (☞ Page 25)
→ New hard disk drive will be formatted automatically. →
When the formatting is completed, the hard disk
drive will become operable.
When the hard disk drive is formerly used for record-
ing, perform the link process (☞ Operating
Instructions (PDF)) on the "HDD management" page.
The status of hard disk drive can be checked on the
setup menu - the "Maintenance" page - the "HDD
information" tab. (☞ Operating Instructions (PDF))