Replacement Parts; Safety Instructions; General Information - Daikin DCC Series Installation Instructions Manual

Air flow Adjustments .................................................... 11
Motor Sheave Adjustments .........................................12
Heat Pump Operation ...................................................14
Maintenance ..................................................................15
Troubleshooting ...........................................................16
Appendix A Blower Performance Data .......................17
Belt Drive - Standard Down Shot ................................17
Belt Drive - Standard Horizontal .................................18
Belt Drive - High Static Down Shot ............................19
Belt Drive - High Static Horizontal ............................20
Appendix A Economizer Pressure Drop .....................21
Appendix B Electrical Data ..........................................22
Appendix C Unit Dimensions ......................................31
Appendix D Wiring Diagrams ......................................32
Wiring Diagrams For Models With DDC .....................37
Start-Up Checklist ........................................................46

REPLACEMENT PARTS

O P
rDering arts
When reporting shortages or damages, or ordering repair
parts, give the complete unit model and serial numbers
as stamped on the unit's nameplate.
Replacement parts for this appliance are available
through your contractor or local distributor. For the
location of your nearest distributor, consult the white
business pages, the yellow page section of the local
telephone book or contact:
EQUIPMENT SUPPORT
DAIKIN NORTH AMERICA LLC
19001 KERMIER ROAD
WALLER, TEXAS 77484
855-770-5678

SAFETY INSTRUCTIONS

t t i
O He nstaller
Before installing this unit, please read this manual to
familiarize yourself on the specific items which must be
adhered to, including maximum external static pressure
to unit, air temperature rise, minimum or maximum CFM
and motor speed connections.
Keep this literature in a safe place for future reference.
S ,
HEET METAL PARTS SCREWS
,
HAVE SHARP EDGES AND IT IS NECESSARY THAT THE INSTALLER AND
SERVICE PERSONNEL EXERCISE CAUTION
CAUTION
,
CLIPS AND SIMILAR ITEMS INHERENTLY
.
T
O AVOID PROPERTY DAMAGE
NOT USE THIS UNIT IF ANY PART HAS BEEN UNDER WATER
I
MMEDIATELY CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT
THE FURNACE AND TO REPLACE ANY PART OF THE CONTROL SYSTEM
AND ANY GAS CONTROL HAVING BEEN UNDER WATER
T
HIS UNIT MUST NOT BE USED AS A
DURING THE FINISHING PHASES OF CONSTRUCTION ON A NEW
. T
STRUCTURE HIS TYPE OF USE MAY RESULT IN PREMATURE FAILURE
OF THE UNIT DUE TO EXTREMELY LOW RETURN AIR TEMPERATURES
AND EXPOSURE TO CORROSIVE OR VERY DIRTY ATMOSPHERES
HIGH VOLTAGE!
D
ISCONNECT ALL POWER BEFORE SERVICING OR
. M
INSTALLING THIS UNIT
. F
BE PRESENT AILURE TO DO SO MAY CAUSE PROPERTY
,
DAMAGE PERSONAL INJURY OR DEATH
T
O PREVENT THE RISK OF PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH,
DO NOT STORE COMBUSTIBLE MATERIALS OR USE GASOLINE OR OTHER
FLAMMABLE LIQUIDS OR VAPORS IN THE VICINITY OF THIS APPLIANCE.

GENERAL INFORMATION

For complete information and installation instructions for
models with DDC controls, see manual DK-DDC-TGD-
XXX.
T
O PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DUE TO FIRE,
EXPLOSIONS, SMOKE, SOOT, CONDENSATION, ELECTRIC SHOCK OR CARBON
MONOXIDE, THIS UNIT MUST BE PROPERLY INSTALLED, REPAIRED, OPERATED,
AND MAINTAINED.
This unit is approved for outdoor installation ONLY.
Rated performance is achieved after 72 hours of operation.
Rated performance is delivered at the specified airflow. See
outdoor unit specification sheet for split system models or
product specification sheet for packaged and light commercial
2
WARNING
,
PERSONAL INJURY OR DEATH
.
WARNING
"
CONSTRUCTION HEATER
WARNING
ULTIPLE POWER SOURCES MAY
.
WARNING
WARNING
,
DO
.
"
.