Counterbalance - Siemens MOBILETT Plus Service Instructions Manual

Mechanical systems
Friction lining
Fig. 4 For upper arm stability
Adjustment screw
Fig. 6

Counterbalance

•
Remove the plastic plugs covering the friction linings in the column.
•
Loosen the friction linings through the holes in the column (Fig. 4) and the lining in the
lower joint (Fig. 5).
•
Check that the arm system stops in any position.
If does not stop, but moves lower or higher:
•
Adjust the arm system with the adjustment screw (Fig. 6), until it balances in all positions.
If the arm moves lower, the screw must be tightened; if it moves up, the screw must be
loosened.
Siemens-Elema AB
Solna, Sweden
!
Friction lining
Fig. 5 For lower arm stability
SPR8-215.898.01
Rev. 05 01.02
Page 3 of 28 MOBILETT Plus / - E/ - M
SPS-UD
10 - 3
10