Replacing The Friction Linings; Replacing The Horizontal Friction Lining - Siemens MOBILETT Plus Service Instructions Manual

10 - 24
Fig. 27

Replacing the friction linings

Replacing the horizontal friction lining

•
Remove the joint covers.
•
Remove the locking nut.
•
Remove the screw and the disc springs.
•
Replace the horizontal friction lining.
•
Remount the screw and the the disc springs (fig. 27). Secure the screw with the locking
nut.
•
Adjust the horizontal friction linings. Refer to the section: "Adjustment of the friction
linings", Page 10 - 4.
•
Reattach all covers.
MOBILETT Plus / - E/ - M
Locking nut
SPR8-215.898.01
Rev. 05 01.02
Mechanical systems
Disc springs
Friction lining
Page 24 of 28 Siemens-Elema AB
SPS-UD
10
10
Solna, Sweden