Table of Contents
Advertisement
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector.
You may also configure two hard disks to be both Masters
using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
• Two hard disks can be connected to each connector. The
first HDD is referred to as the "Master" and the second HDD
is referred to as the "Slave".
• For performance issues, we strongly suggest you don't install
a CD-ROM or DVD-ROM drive on the same IDE channel as a hard disk. Otherwise, the
system performance on this channel may drop.
(10) Serial-ATA Port connector:
SATA1 / SATA2 / SATA3/ SATA4
These connectors support the provided Serial
ATA and Serial ATA2 IDE hard disk cable to
connecting the motherboard and serial ATA
hard disk.
(11) Serial COM Port: COM1 (Optional)
COM1 is the 9-pin connector. The On-board serial port can be disabled through BIOS
SETUP.
(12) VGA Connector (15-pin D-Sub) Connector: VGA1
VGA is the 15-pin D-Subminiature female connector for
display monitor.
3-2 Headers
(1) Line-Out/MIC Header for Front Panel (9-pin): AUDIO1
This header connect to Front Panel Line-out, MIC connector
with cable. Without install the cable, this header default
setting is 5-6 short, 9-10 short. When you install the cable
you have take off these jumpers.
(2) USB Port Headers (9-pin) :
USB2 / USB3
These headers are used for connecting the
additional USB port plug. By attaching an
option USB cable, your can be provided
with two additional USB plugs affixed to the
back panel.
SATA4
SATA3
SATA2
SATA1
Serial-ATA1 & 2 Compatible Connectors
USB2
Pin 1
USB Port Headers
10
IDE1
IDE1
Pin 1
Primary IDE Connector
AUDIO
2
10
Pin 1
9
Line-Out, MIC Headers
USB3
Pin 1
Advertisement
Table of Contents
