Table of Contents
Advertisement
Wireless Setup
GateKeeper
After setting up the above configurations, please click 'Apply' and then 'Reboot System' to
allow all changes take effect.
You can configure the wireless network. Available settings are:
Region: Select the country of your residence, this will affect available
wireless radio channel. Selecting a different country may offend local
radio regulation and cause legal problem.
SSID: You can change the Service Set Identifier (SSID, the name
used to identify this projector server from other wireless devices) by
input another SSID here. Default SSID is WPS. (No space is
allowed)
Channel: You can change the channel number of wireless network
from dropdown menu here. Available channels will vary depending
on the region you selected. You can select 'Auto' to let projector
server decides which channel to use.
WEP: Select the wireless encryption level and key type. Available
options are 128bit (13 ASCII characters or 26 Hexadecimal
characters) and 64bit (5 ASCII characters or 10 Hexadecimal
characters). You can also select 'Disable' to let everyone connect to
the projector server wirelessly without the encryption.
Key: Input the WEP key here. Required number or characters will
vary depending on the encryption level and key type.
This projector server has a built-in firewall to isolate wireless users
and LAN. If you select 'All Pass', wireless users connected to this
projector server will be able to access the wired Ethernet network
connected to this projector server; if you select 'All Block', wireless
users will not be able to access the wired Ethernet network, to keep
privacy (this is also the default setting). If you want to let guests to
access to the Internet, you can select 'Internet Only', to let guests
visit web pages on internet through the wired Ethernet network
connected to this projector server. (Refer Appendix on set up the
projector server to the Internet).
38
Advertisement
Table of Contents
