Table of Contents
Advertisement
2. Refer to figure 2b. Slide a Finger Guard (54) onto
the pins on the Left Pivot Bracket (7). Note: The
Finger Guards may already be attached.
Find the Left Link Arm (11), which is labeled with a
ÒleftÓ sticker. Make sure that there are two Bronze
Bushings (16) in each end of the Link Arm. Slide
one end of the Link Arm onto the indicated pin on
the Left Pivot Bracket (7). Make sure that the Link
Arm is turned as shown in figure 2c. Tap a 3/8Ó
Axle Cap (40) onto the pin. Slide the other end of
the Link Arm onto the pin on the Rocker Arm (9).
(Note: It may be necessary to pivot the Rocker Arm
and the Left Leg [3] slightly.) Tap a 3/8Ó Axle Cap
(40) onto the pin.
Attach the other Finger Guard and the Right Link
Arm (not shown) in the same manner.
3. Attach the Right Frame Section (6) to the Right
Upright (2) with an M10 x 138mm Bolt (42), a
Plastic Spacer (41), and an M10 Nylon Locknut
(43). Do not tighten the Nylon Locknut yet.
4. Slide the Hip Pad (28) onto the Left Frame
Section (5).
Slide the Left and Right Frame Sections (5, 6)
together. Make sure that the indicated hole is
accessible. If necessary, slide the Hip Pad (28) to
the side. Attach the Frame Sections with an M5 x
16mm Screw (61). Do not tighten the Screw
yet.
Attach the Left Frame Section (5) to the Left
Upright (1) with an M10 x 138mm Bolt (42), a
Plastic Spacer (41), and an M10 Nylon Locknut
(43).
Tighten all parts used in steps 1, 3, and 4.
Slide the Hip Pad (28) so it is centered on the
Frame Sections (5, 6).
Fig. 2a
40
3
9
16
Pin
16
Fig. 3
Fig. 4
28
5
41
42
1
6
7
Pin
16
Fig. 2b
11
54
Fig. 2c
Long
Side
40
11
43
41
2
6
Hole
61
43
7
Pins
Pin
7
42
6
Advertisement
Table of Contents
