NM1850
MAINTENANCE: Air Cooled
5. Clean each air cooled condenser. Use a
vacuum cleaner or coil cleaner if needed. Do NOT
use a wire brush.
////////////////////////////WARNING///////////////////////////////
Disconnect electrical power.
/////////////////////////////////////////////////////////////////////////////
A. Remove top panel.
TOP
PANEL
B. Remove two screws, and unplug the fan motors.
LOCATING
PINS
C. Pull fan motor assembly off of locating pins
and out of the unit.
CAP SCREW
UNPLUG
LEADS
D. Clean the condenser; reassemble by
placing the fan motor assembly onto the
loacting pins, replacing the mounting screws,
plugging the fan motors back in, and
replacing the top panel. Reconnect power.
May, 1989
Page 18
FAN MOTOR
ASSEMBLY