Scotsman NM1850 Manual page 15

OPERATION: Refrigeration
The following description applies to each of the two separate ice making systems.
Beginning at the compressor, the refrigerant
502 is compressed into a high temperature
gas. The discharge line directs this gas to the
condenser. At the condenser (air or water
cooled) the gas is cooled by either air or water
and it then condenses into a liquid. This high
pressure liquid then goes through the liquid
line to the expansion valve. The thermostatic
expansion valve meters liquid refrigerant into
the evaporator, the volume of liquid refrigerant
depending upon the temperature of the
evaporator; warmer evaporators get more
refrigerant and colder evaporators get less.
CONDENSER
FAN
MOTOR
HIGH PRESSURE
CUT OUT SWITCH
Refrigeration Schematic
LIQUID
LINE
At the evaporator, the refrigerant enters an
area of relatively low pressure, where it can
easily "boil off" or evaporate. As it
evaporates, it absorbs heat from the
evaporator and whatever is in contact with it
(such as the water inside it). After the
evaporator, the refrigerant, now a low
pressure vapor, goes through the suction line
back to the compressor, where the cycle is
repeated.
DISCHARGE
LINE
THERMOSTATIC
EXPANSION
COMPRESSOR
May, 1989
Page 15
SUCTION LINE
EVAPORATOR
VALVE
NM1850
GEAR
MOTOR