Advertisement
5. ASSEMBLY
5.1.
Secure the saw to a workbench or a stable work stand by inserting four screws through the holes in the machine's feet.
The area should be well lit and have suffi cient room to use the machine safely.
5.2.
ATTACH CLAMPING DEVICE
5.2.1.
The clamping device can be secured to the left or right side of the fi xed saw table.
5.2.2.
Insert the clamping device (fi g 4 - 7) into the hole in the fi xed saw table (fi g 6 - 15) on the rear side of the stop rail (fi g 4 - 16).
5.2.3.
Secure at the height required with star grip screw (fi g 4 - 7a).
5.3.
ATTACH WORKPIECE SUPPORTS
5.3.1.
Position workpiece assembly (fi g 6 - 8) into holes in side of fi xed saw table (fi g 6 - 15).
5.3.2.
Repeat on other side.
5.3.3.
Secure in required position with locking screw (fi g 6 - 9).
5.4.
ATTACH THE SAWDUST BAG
5.4.1.
To attach the sawdust bag (fi g 1 - 17) squeeze together the metal ring on the dust bag and slide onto the dust outlet port and
secure by releasing the pressure on the metal ring.
5.4.2.
To empty the sawdust bag, remove it from the dust outlet port by squeezing the metal ring and empty by unzipping the slide
fastener, into a suitable waste container.
5.4.3.
Re-attach the sawdust bag as section 5.4.1.
NOTE: If using the saw with dust extraction, use a suitable adaptor to attach to the saw dust outlet port.
5.5.
TO ROTATE THE TURN TABLE
5.5.1.
To rotate the turn table (fi g 4 - 14) unscrew the locking handle (fi g 5 - 11) by approx. 2 turns, and lift up the release lever (fi g 5 - 28).
5.5.2.
Turn the turn table and pointer (fi g 4 - 12) to the required angle measurement on the scale (fi g 4 - 13), and secure by re-tightening
the locking handle.
5.6.
DISENGAGE THE SAW FROM THE LOWEST POSITION
5.7.
When boxed, during storage or transportation, the saw head is required to be locked in the down position.
5.7.1.
To release the machine head (fi g 3 - 4) ready for operation, apply downward pressure and remove the fastening bolt (fi g 3 - 23).
The machine head will raise slowly to it's upper position.
6. OPERATION
NOTE: Ensure all Safety Instructions in Section 1 are read and understood and carried out before use.
WARNING! To prevent accidental starting that could cause possible serious injury, assemble all parts, make sure adjustments are
complete, and make sure all fasteners are secure before connecting to the power supply.
WARNING! The saw should never be connected to the power supply when you are assembling parts, making adjustments,
installing or removing blades and when not in use.
6.1.
TURNING ON AND OFF
6.1.1.
To turn the saw on move the lock-off lever (fi g 7 - 3) to the left, and depress and hold the on/off trigger switch (fi g 7 - 2).
6.1.2.
To turn the saw off , release the on/off trigger switch (fi g 7 - 2).
WARNING! Allow the blade to reach full speed before contacting the workpiece.
© Jack Sealey Limited
fi g.4
fi g.3
fi g.6
fi g.5
Original Language Version
SMS255.V3 Issue 1 21/05/21
Advertisement
