Steps
1. Hold the 3.5-inch hard drive against the chassis and align the four (#6-32) grommet screws on the hard drive with the
screw holes on the chassis.
2. Slide the 3.5-inch hard drive down to lock the four grommet screws on to its screw holes on the chassis.
3. Connect the power cable and data cable to the connectors on the hard-drive module.
Next steps
1. Install the
fan
duct.
2. Install the
side
cover.
3. Follow the procedure in
Solid-state drive
Removing the M.2 2230 PCIe solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
fan
duct.
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
23