Table of Contents
Advertisement
OPERATION
Power On And Self-Test
Each time your Whistler detector is turned on, an auto-
matic self-test sequence confirms that the speaker and
visual displays are functional.
• Press
(Power) or apply Power. Display reads:
Integrated Real Voice
When selected, Real Voice will be used to articulate the
following:
1. Band Identification
2. Safety Warning System messages
NOTE: In certain cases the voice message does not repli-
cate the text message.
3. Feature Selection
10
OPERATION
Memory/Beep Confirmation
All features selected (except Stay Alert and Quiet) are
retained in memory. Each time a button is pressed one
beep confirms feature "on", two beeps confirm feature
"off".
Audio Level Adjustment
The audio levels can be adjusted high to low, or low to
high, in nine steps: (0) is no audio level, (8) the highest.
• Press Volume
up to increase audio level.
• Press Volume
down to decrease audio level.
As audio level is adjusted, beeps are provided and the
display indicates volume level. Example:
VOL
VOL
VOL
VOL
VOL
O
O
O
O
O
Compass Mode
The 1783/93SE is programmed from the factory in
"Combo Mode". Combo mode means that the unit pro-
vides both compass readings as well as detecting
laser/radar signals. Through the "Option Select Mode"
(page 16) or the "Mode" Button, the unit can be changed
to operate in Radar Mode (detection of all police bands
and laser (no compass) or Compass Mode (no detection of
police laser radar). Note: The unit must be calibrated to
provide accurate compass readings.
Calibration Set-up section on page 9.
11
See Compass
Advertisement
Table of Contents
