Advertisement
2h. PROGRAMMING THE TRANSMITTER TO THE SKYLINKHOME
2h. PROGRAMMING THE TRANSMITTER TO THE SKYLINKHOME TM SCREW-IN CONTROL – LG-318
1. Turn off the light switch of the empty socket where you plan to install the
Mini Screw-In Control.
2. Screw the Mini Screw-In Control to the empty socket.
3. Screw a light bulb to the fixture.
4. Power on the Mini Screw-in Control. It will beep.
5. It is now in programming mode and will stay in this mode for 15 seconds.
6. Press any one of the buttons on the transmitter that you want to program to
the receiver.
7. Once the transmitter is programmed, the Mini Screw-In Control will beep
once and the connected device/light turn on. You have successfully
programmed the transmitter.
NOTE: If the receiver or control module you wish to program isn't listed here, please refer to the receiver's
user manual for instructions.
3. OPERATION
Press the programmed button to open/close the garage door or receiver.
4. BATTERY REPLACEMENT
The remote come with a 3 Volt lithium battery (CR 2032) installed. It is time to change the battery when the red LED
on the transmitter does not turn on when either button is pressed.
To replace the battery：
1. Remove the screw on the back of the remote.
2. Pry out the back cover from the remote
3. Take out the old battery.
4. Place the new battery in position. Be sure the polarity is correct.
5. Close the back cover with the screw.
Battery Disposal - Dispose used battery according to local regulations.
5. FAQ
Q: What can I do if the door opener does not react after I press the button on the transmitter?
A: - Ensure when the button on the transmitter is pressed, the red light on the transmitter comes on. Otherwise,
check if the battery is inserted properly.
- Make sure the correct button on the transmitter is pressed.
- Ensure the transmitter has been programmed to the receiver. Refer to section 2 for how to program a
transmitter to the receiver.
SCREW-IN CONTROL – LG-318
TM
1
2
3
OF F
6. FCC
7. FCC
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
WARNING:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
7. WARRANTY
If, within one year from date of purchase, this
product should become defective (except battery),
due to faulty workmanship or materials, it will be
repaired or replaced, without charge. Proof of
purchase and a Return Authorization are required.
8. CUSTOMER SERVICE
If you would like to
- find out the up-to-date specifications
- know more about features and applications
- download documents, i.e. user's instructions
- order Skylink products
or if you have difficulty getting products to work, please:
1. visit our FAQ section at www.skylinkhome.com, or
2. email us at support@skylinkhome.com, or
3. call our toll free at 1-800-304-1187 from Monday to
Friday, 9 am to 5 pm EST. Fax 1-800-286-1320
CUSTOMER SERVICE
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email:support@skylinkhome.com
http://www.skylinkhome.com
©2016 SKYLINK GROUP
Advertisement
