Equipment - Echo GT-225L Operator's Manual

SAFETY

Equipment

Use only approved attachments. Serious injury may result from
the use of a non-approved attachment combination. ECHO INC.
will not be responsible for the failure of cutting devices,
attachments or accessories which have not been tested and
approved by ECHO INC. Read and comply with all safety
instructions.
Check unit for loose or missing nuts, bolts, and screws.
◆
Tighten or replace as needed.
Inspect shield for damage and ensure that shield is
◆
properly installed, and that the cut-off knife is securely in
place. Replace if either is damaged or missing.
Check that the cutting attachment is firmly attached and in
◆
safe operating condition.
Assure that throttle trigger, throttle trigger lockout, and
◆
stop switch all work properly.
Check that handle and harness (if included) are adjusted
◆
for safe, comfortable operation. See Assembly Section for
proper adjustment.
Moving parts can amputate fingers or cause severe injuries.
Keep hands, clothing and loose objects away from all openings.
ALWAYS stop engine, disconnect spark plug, and make
◆
sure all moving parts have come to a complete stop before
assembling unit, removing obstructions, clearing debris, or
servicing unit.
Do not connect spark plug lead to spark plug unitl unit is
◆
ready for use.
DO NOT start or operate unit unless all guards and
◆
protective covers are properly assembled to unit.
NEVER reach into any opening while the engine is running.
◆
Moving parts may not be visible through openings.
Position wiring safely to prevent snagging, separation of
◆
connectors, or breakage during operation. Gather excess
wire, and secure with wiring clamp if provided on
equipment, or tuck behind the air filter area. Do not place
wiring directly against hot engine components.
12
GT-225L
X7732272601
© 3/2019 ECHO Inc.