Lubrication - Echo GT-225L Operator's Manual

GT-225L
1. Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw (A)
should be set to the
specifications found on
"Specifications" page of this
manual. Turn idle screw (A)
clockwise to increase idle
speed; counterclockwise to
decrease idle speed.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious personal
injury may result.

Lubrication

Level 1.
Parts Required:
1. Remove shield.
2. Loosen bearing housing
locating screw (A), at the top of
the housing, loosen mounting
screw (B) and remove gear
case from drive housing.
3. Pull the flexible drive shaft (C)
from the drive housing, wipe
clean and apply 15 ml (0.5 oz.)
of grease.
4. Slide the flexible drive shaft
back in the drive housing being
careful not to get dirt on the
flexible drive shaft.
5. Install the bearing housing and shield.
X7732272601
© 3/2019 ECHO Inc.
Lithium Based Grease.
MAINTENANCE
B
A
C
33