Disconnecting Your Dishwasher - EdgeStar DWP61ES Owner's Manual

EdgeStar Dishwasher
8. Slowly open the hot water line and c
connections. If leaks are located, imm
repair the hose connections.
If your existing faucet adapter is not compatible with the "quick connect" hose
assembly sup plied, then the following procedures should be followed:
• Connect the faucet adapter (included with dishwash
• If your faucet is inclusive of a 'female' type (thre
washers must be installed inside the
If your faucet is inclusive of a 'male' type (thread
•
standard rubber washer (0.2"/5mm thick) sup lied within the adapter. Remove
the second rubber washer.
For Best Results:
Y our dishwasher cleans by spraying
(u nder pressure) against the soiled surfaces of dishes. The water is
th rough a rotating spray arm, drained through a filter (removing food and soiled
p articles) and pumped back through the spray arm. Soiled water is pumpe
a nd replaced with clean water at the end of each cycle (the number of times this
is repeated depends on the wash cycle chosen).
NOTE:
Hard water conditions will adversely affect the washing per
dishwasher. Hard water conditions will also
substance) deposits and/or 'scaling' on t
dishwasher tub and heater element, loca
removable filter screen. To assis
recommended to periodically operate/rinse the
using 1 cup of white vinegar at least once a week.
D isconnecting your Dishwasher
1. Close the hot water supply at the faucet.
2. Disconnect the power supply cord.
3. Remember to release the water pressure inside the inlet hose.
4. The inlet hose is pressured when the water supply line is opened, even if
closed immediately.
5. To release pressure: press and hold the red pressu
quick-connect assembly until the flow of water stop
6 . Disconnect the quick-connect hose assembly by pulling down on the outer
locking collar, thus releasing it from the faucet adapter.
•
Failure to relieve water pressure before disconnecting the Quick
Connect assembly from the Faucet Adapter may result in backpressure
overspray.
•
The inlet water temperature can be EXTREMELY HOT!
•
Backpressure overspray could cause SEVERE BURNS and/or
SCALDING!
heck for any sign of water leaks at all
ediately close the water supply and
er) to your faucet.
aded) connection, both rubber
faucet adapter.
ed) connection, use only the
p
a m ixture of clea n hot water and dete
contribute to 'lim
he stainless steel surface of the
ted in the sump underneath the
t in minimizing these conditions, it is
inside of the dishwasher (empty)
re relief button on the
s.
rge nt
pumped
d out
formance of your
e' (white film
6