Opel Vivaro Manual page 116

116 Vehicle care
1. Remove bulb holder from reflector
housing by rotating through 90°.
2. Renew bulb.
3. Install bulb holder in reflector
housing.
Tail lights
Rear brake, turn signal and tail
lights
1. Remove 3 screws (using the tool
supplied).
2. Carefully pull lamp assembly from
retaining pins on the outer side
and remove.
3. Twist bulb holder to separate from
lamp assembly.
4. Renew bulb.
5. Push to install the bulb holder into
the lamp assembly - then twist to
secure.
6. Check that the wiring harness is
located correctly.
7. Replace lamp assembly into
original position, ensuring that it is
seated correctly.
8. Fit lamp assembly onto retaining
pins and replace 3 screws.
Side turn signal lights
1. Release clips from wing using
a flat blade screwdriver and lift out
lamp assembly from aperture.
2. Remove bulb holder from lamp
assembly by rotating through 90°
and renew bulb.
3. Install bulb holder in lamp
assembly and install lamp
assembly into aperture.
Centre high-mounted
brake light
Have bulbs replaced by a workshop.